There are our standard tools. They should always remain the same as listed here. That said, call up each tool that you’ll be using before running a program to confirm that they are correct.
If you load a tool into the mill, measure it off the table probe immediately.

Standard Tools

Tool #	Tool Type	Tool Holder
T1	3/8″ 0.375 Bull Nose	ER32
T2	1/4″ 0.250 Square	ER16
T3	1/8″ 0.125 Square	SlimFit
T4	3/32″ 0.0937 Square	SlimFit
T5	1/16″ 0.0625 Square	SlimFit
T6	1/32″ 0.03125 Square	SlimFit
T7	1/4″ 0.250 Ball	ER16
T8	1/8″ 0.125 Ball	SlimFit
T9	3/32″ 0.0937 Ball	SlimFit
T10	1/16″ 0.0625 Ball	SlimFit
T11	1/32″ 0.03125 Ball	SlimFit
T12	1/8″ 0.125 45° Chamfer	SlimFit
T13	1/4″ 0.250 Center Drill	ER16
T14	1/8″ 0.125 Drill	ER16
T15	Keyless 3-Jaw Drill Chuck
T16-T19	These tools are non-standard and used for DesignLab projects.	ER16 2.5″
T20-T23	These tools are non-standard and used for DesignLab projects.	ER16 4.0″
T24-T27	These tools are non-standard and used for DesignLab projects.	SlimFit
T28	Slit Saw	ER32
T29	1mm	OMP40-2
T30	2″ Shell Mill	ER32
T31	6mm Probe	Renishaw Probe